Cut the end decoration and lay out the notches.Cut a joist to 182-1/2 in. long. Then strike a line across the joist located 15 in. from each end. Lay out and cut the end decorations as you did for the beams.
People also ask
What is an elliptical cut for a pergola?
One of the design elements is an elliptical cut making the sweep in the bottom of these haunches that will hold other parts of the pergola. In this video, I want to show the process I use for creating smooth, consistent, accurate results considering the method uses basic shop tools.
What are the edges of a pergola called?
Each one, while built on the same principles, can look vastly different. Take the rafter tailsthese are the decorative edges where the rafters cantilever outside the pergola’s four-sided frame. They’re a focal point, and spending a little time designing them is a good way to distinguish the entire structure.
What size Brads do I need for a pergola?
15:17: A couple of number 18×5/8-inch brads are more than enough to hold this pattern permanently in place with this angle cut perfectly flushed with the saw cut and made with the miter box. This joist ends up being a skinny 9-1/4 inches, so the template hangs over the bottom just a little bit, and for a pergola, that’s not gonna be an issue.
What’s your favorite thing about pergolas?
One of my favorite things about pergolas is how unique they can be. Each one, while built on the same principles, can look vastly different. Take the rafter tailsthese are the decorative edges where the rafters cantilever outside the pergola’s four-sided frame.